Lippert-components In Wall Slide-Out System Manual do Utilizador descarregar pdf (Página 11)

*********Do not push shaft up further than 1 ½ inches.************

b. The coupler will be lifted above the motor mount and can be removed with a pair of needle nose

pliers or hemostats.

7. The coupler needs to be placed onto the end of the drive shaft, inside the motor mount, at the

top end of the column. Note the splines on the drive shaft and motor coupler.

The coupler can be rotated while pushing down, or the side column can be pushed back and forth

while pushing down, to engage the splines. The coupler should be pushed down below the top of the

motor mount.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Lippert-components In Wall Slide-Out System Manual do Utilizador Página 11