Lippert-components Hydro-Sync Slideout System Manual do Utilizador Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 13
ROOM DOESN' T MOVE WHEN SWITCH IS PRESSED
PROBABLE CAUSE CORRECTIVE ACTION
Rest ri ct ions bot h inside and out si de of unit Check f or and clear rest rict ion
Low bat t ery volt age, bl own fuse, defective wiri ng Check bat tery. Charge bat tery or add auxil iary
power source. Check bat tery terminals, and al l
ot her wiring. Look for loose or corroded
co nnect i ons
Power Unit not f unct ioni ng See " Power Unit Troubleshoot ing" page 13
POWER UNIT RUNS, ROOM DOES NOT MOVE
Rest ri ct ions bot h inside and out si de of unit Check f or and clear rest rict ion
POWER UNIT RUNS, ROOM MOVES SLOWLY
Low bat t ery, poor ground, ext remely low Charge bat tery, and check ground wire
out door t emperat ure.
Leaking cylinder See "Checki ng for Bad Cylinder" page 14
ROOM DRIFTS IN BOTH IN & OUT POSITIONS
Check f or l eaks in t he hydraulic syst em Ti ghten f it tings
Air in system After checking all connections, cycle pump
several times in and out
IN THE CLOSED POSITION, ROOM DRIFTS OUT
Leaking cylinder seal See "Checki ng for Bad Cylinder" page 14
Fl uid bypassing cylinder pist on See "Checki ng for Bad Cylinder" page 14
Hose from pump i s leaking Tighten f it ti ng or replace hose
Air in system After checking all connections, cycle pump
several times in and out
Loose mounti ng bolt s Tighten mount ing bolt s
IN THE OPEN POSITION, ROOM DRIFTS IN
Hose from pump i s leaking Tighten f it ti ng or replace hose
Leaking cylinder seal See "Checki ng for Bad Cylinder" page 14
Fl uid bypassing cylinder pist on See "Checki ng for Bad Cylinder" page 14
TROUBLESHOOTING CHART
The following troubleshooting chart outlines some common problems, their causes and
possible corrective actions. When reference is made to a “Power Unit,” the term
includes the motor and the actuator as a complete unit. All Power Units are shipped
from the factory with a serial number and date code, which should be given to the
service technician when asking for assistance.
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários